A logic analyzer is a device which can monitor the high and low states of several input lines of a digital logic. It is useful for debugging digital circuits such as bus transfers, etc. You can imagine a logic analyzer to be something like a digital oscilloscope.

Normally, a logic analyzer is a external device with a own controller that has a own display or is connected to a PC via USB or serial line. The PC or the display then shows the data, e. g. some waveforms.

This logic analyzer is designed to be cheap, somehing like a logic analyzer for poor men, which means not for industrial use but for hobbyists. It simply consits of a schematic which is attached to the PCs parallel port. Therefore, 8 Bit (i. e. 8 data lines) can be monitored simultaneously.

There's no real external device which collects the data: The schematic just protects the parallel port and converts RS232 level (+/- 12 V) to 5 V TTL level on two pins configurable with jumpers. The schematic is described later in this manual. The measuring is done by the PC software using the parallel port.

This means that the speed depends on your PCs parallel port and on the operating system. The data ist just collected by a user process to be portable against different operating system. However, with my setup I get on Linux data rates about 1 MHz which is quite well for I²C, RS-232, SPI and some other stuff.

The software has following features:

TFLA-01 is designed to be portable against various operating systems. It is written in C++, uses Qt as cross-plattform API mostly for the graphical user interface and libieee1284 to access the parallel port. This means that it is possible to run TFLA-01 on following systems:

On hardware side, you need a parallel port. Use the port of your mainboard or a additional PCI card. Forget about USB adapters, they are normally designed for printers and for nothing else and if it would work, the speed would be insuitable for a logic analyzer. (Of course, USB is faster than a parallel port, but that does nothing say about the speed of such adapters.)

Starting with version 0.3.0 it's also possible to create a viewer-only version of TFLA-01. This version doesn't need libieee1284 and cannot collect data from the parallel port. It just can open TFLA-01 files that have been saved by another version of TFLA-01 (with parallel port access). If no libieee1284 is available, the build system warns about missing functionality but automatically builds such a version. However, such binaries are not distributed at the TFLA-01 website. This version also works on Mac OS.